New Turnigy Plush, Basic, Sentry and Pentium boards (Hobbywing OEM).
Use at your own risk, and always test first without propellers!.
If it breaks, you get to keep both pieces!.
Hobby King SS models with "-HW" in part number.
RCTimer 10A, 18A, 20A, 30A, 40A (18A, 20A, 30A are same board with more or less FETs).
Original Turnigy Basic and Turnigy Plush 10A, 18A, and 25A (Hobbywing OEM).
tgy (these boards typically have no external resonator):.
#Fms esc throttle stick calibration drivers#
TowerPro 70A with BL8003 FET drivers (inverted low side).
Newer TowerPro 25A with inverted low side (BL8003 drivers).
tp modified for I2C input (old ADC4 routed to ADC1).
tp at 8kHz PWM (workaround for DYS/HK-SS clones with PWM noise problems).
Hobby King SS models without "-HW" in part number.
Team BlackSheep TBS 30A ESC (ICP input version).
Hobby King Red Brick 200A (RB200A-BTO, black board).
MikroKopter BL-Ctrl v1.x (flashable by ISP only).
Hobby King Multistar series (30A and under).
Keda 12A rev B with inverted PWM input (30A should also work).
Hobby King SS Series 190-200A (HK-SS200ALV).
Pulso Advance Plus DLU40A with opto-isolated inverted PWM input.
Hobby King BlueSeries 40A (and some Mystery 40A boards).
Hobby King Red Brick 200A (RB200A, black board).
AfroESC HV (high voltage, with all-N FETs and drivers).
Reverse-neutral-forward PWM ranges, with optional brakingįor a more complete list.
Forward and reverse commutation supported, including RC-car style.
Configurable board pin assignments by include file.
Optimized interrupt code (very low minimum PWM and reduced full.
#Fms esc throttle stick calibration update#
Accepts any PWM update rate (minimum ~5microseconds PWM low time).
Response (but NOT where soft start or really any significant current
Immediate PWM input to PWM output for best possible multicopter.
ICP-based pulse time recording (on supported hardware) for zero PWM.
24-bit timing and PWM pulse tracking at full clock rate resolution.
16-bit output PWM with full clock rate resolution (~18kHz PWM with.
Patches and comments are always welcome! Let me know how it goes! Features TowerPro 18A and original (not current!) Turnigy Plush boards. "tp-18a" software, which was a port from his earlier personal work to the Sensor-less motor electronic speed control (ESC) boards, originally for This tree contains Atmel AVR assembly code for ATmega-based 3-phase